6/12/2023 0 Comments Lightwave 3d tutorials pdf![]() We used the Thicken tool to create an inner surface and a reasonably thick wall. A hollow torso would not only make for a lighter statue, but also a cheaper print. In 3D printing, the less material used, the less costly the print. However, a solid torso would have used a lot more material and cost a small fortune. One solution might have been to patch over this lower torso hole, sealing it off and fulfilling the “watertight” mesh requirements for 3D printing. Although the arm holes were now sealed, the alien was still a shell with no thickness. The results spackled over the arm holes nicely (08). Then used Bevel to give these n-gons a bit of an inset, then the Spikey Tool with a 0% Spike Factor to convert the n-gons into triangles. We patched the arm holes using Make Poly.
0 Comments
Leave a Reply. |